|
This machine is used to cut all types of leather, plastic and
fabric upper material. It is also used for cutting sock linings,
outsoles, linings and insole board. Various heights of dies may
be interchanged without machine adjustment if the machine has
first been adjusted to the highest die. Lighter-weight dies costing
25-40% less than conventional open clicking dies can be used,
as they are not subject to the pounding abuse of the conventional
open clicking dies on mechanical-type machines. The machine builds
up only sufficient pressure to complete the cut, regardless of
the die size.
The beam is of light alloy for easy swinging. Availability of
two and four beam sizes makes the machine adaptable for
all shoe factory requirements. The control circuit is
completely transistorized, designed for dependable operation
and practically no maintenance cost. The control circuit,
plus spring return of the beam, contribute to faster machine
cycle time.
Impact, noise and vibration have been virtually eliminated, which
greatly reduces operator fatigue. Production increases from 6-10%
have been noted over mechanical clicking machines. Weight and
floor space required have been reduced approximately 25% as compared
to C-frame models.
Adjustments are few and simple. Through the stroke control
switch and adjusting for length of stroke, it is possible
to operate straight hydraulic without the Hytronic feature
for cutting conductive, as well as non-conductive, materials.
|
